Today I’ve got a tutorial and reveal of the completed board & batten wall, created in collaboration with The Home Depot Canada. Since I’m usually learning as I go, The Home Depot staff are who I rely on to answer questions and give advice for whatever project I’m working on.
These are the steps that I followed. It’s important to measure, plan, keep lines level and plumb, nail into studs when possible and when in doubt – ask for advice!
Removing the baseboard was my first step because it was thin and wouldn’t look right with the pine boards. I used a flathead screwdriver to pry it off and it came off much easier than I expected.
Next, I marked all of the studs and finalized the placement of my vertical boards. These boards I had cut to length at The Home Depot Canada. Since I live close to the store I planned to start with only these 1″ x 4″ Pine Select boards and then return to have the horizontal pieces cut. When choosing boards make sure to get ones that are straight. If you don’t know how to check, just ask for assistance. If the boards are warped it makes it more challenging to attach them to the wall.
I used 1 1/2″ spiral finishing nails which were recommended to me since they have more grip than a regular finishing nail. For some boards that don’t stay on the wall flush, I used a few dots of Construction Adhesive to make sure they held.
The next step was to take the measurements between the boards before heading back to get the horizontal pieces cut. The policy is us that you pay after the first two cuts but if you visit when it’s not too busy the staff usually go above and beyond. Having a sketch helps to remember which pieces go where and what lengths are required.
When I got home I started figuring out spacing on the wall. I did have to adjust a couple of boards with my hand saw because I had taken the wrong measurement.
I started with the top pieces and made sure they were in a level line. It turns out that our basement height is quite uneven so to create a level line across the top I left a gap (which will later be covered with moulding). These smaller pieces are held up with 2 -3 nails. Along the bottom edge, I wanted to make sure that in the future if we were going to replace the flooring it would be possible to easily remove the bottom boards.
Painting the bottom pieces before adding them to the wall would have made it much easier. To save yourself some hassle, paint them first!
Where the boards intersected I used a wood filler and sanded once it was dry.
When it comes time to paint, if you’re using a product that has a primer built in you can paint directly onto the wood. Along all of the edges where the boards meet the wall, I ran a strip of caulking along it. I have a caulking gun and have found it to very worthwhile to have. It allows you to purchase tubes of caulking or construction adhesive which are easier to apply than little containers that you squeeze out.
After final sanding, painting and caulking.
This reveal wasn’t about changing everything in the room. The paint colour stayed the same but now the basement has a feature and interest that it didn’t have before.
Thank you to The Home Depot Canada for helping make this vision a reality! If you have an idea of a project but don’t know where to start they are a wonderful resource of information and guidance.
Here’s a little reminder of where it started and some of the steps along the way.
Related Posts:
As featured on
The plan for the basement is to create a board and batten style accent wall using
Here is how the basement looked when we first moved in. Below is how it currently is after I painted it white for a lighter look and refinished the banister. 
Paint has quick and inexpensive results, but the addition of paneling takes it to another level and can expand the sense of space, which can be very useful in a basement. Natural light enters from the stairwell which should add some extra dimension to this wall once the wood is installed.
shibangdesigns.wordpress.com 